This section provides all the information you need to use the Tesi Electric radiator correctly from the very first start-up.
First Start-Up
RADIATOR |
Plug the power cord into the nearest electrical outlet.
After connecting, the radiator will emit two beeps and the LED will turn solid white, indicating that Standby mode (energy-saving) is active.
Press the button on the radiator to exit Standby mode: the radiator will automatically activate Comfort mode, set by default to 20 °C.
REMOTE CONTROL |
Open the compartment by gently sliding the plastic cover.
Insert 2 AAA 1.5 V batteries, observing the correct polarity (+ / –), then close the compartment until it clicks.
Proceed to program the remote control.
ATTENTION
Programming is necessary to ensure the radiator works correctly and that schedules are properly registered.
Subsequent Start-Ups
You can turn on the radiator in two ways:
From the RADIATOR |
- Press botton on the radiator:
If Standby mode is active (white LED):
Pressing the button will make the radiator emit two beeps and return to the last active mode (Comfort, Night, Chrono, etc.). The LED will display the corresponding color.
If another mode is active:
Pressing the button will make the radiator emit two quick beeps and the LED will turn solid white, indicating activation of Standby.
From the REMOTE CONTROL |
Press the Power button to send the turn-on command to the radiator.
The IR transmission icon will flash to confirm the command, and the radiator LED will change color.
Press the Mode button to select a new program. Again, the IR transmission icon will flash to confirm the command.
Tips and Troubleshooting
Find answers to the most frequently asked questions here:
- Remote Control: Buttons and Display
- Tesi Electric Remote Control: Quick Overview
- Tesi Electric Radiator – Modes and Functions
- How to Program the Tesi Electric Radiator
Check the Installation section for all the preliminary information on using the Tesi Electric radiator.
Still need help?
If you’ve followed all the steps and the issue persists, please contact our Customer Service.